Nilfisk MH 5M 210/1110 FA 3 phase Electrical Hot Water Pressure Washer
Free delivery to commercial addresses within Australia!
The MH 5M 210/1110 FA Gives high cleaning and heating performance combined with long life and robustness.
The Tornado Plus double pipe lance has pressure regulation on the lance, and a separate low pressure nozzle for optimal rinsing, which enables using low pressure detergent.
QuickService concept give low running and maintenance costs, robustness, durability and high cleaning efficiency. Service indicator and diagnostics system
Heating costs are reduced with the award winning EcoPower boiler ( > 92% efficiency)
Stainless Steel boiler coil
Safety features include Includes BA Valve back-flow preventor machine protection against low fuel and low pump oil. Also flame sensor and exhaust gas temperature sensor.
Automatic start/stop and delayed action.
Sound level is reduced thanks to the 1450 rpm motor.
Flow-activated control system for operator comfort.
Easy to use control panel: all controls in one place.
Eligible for Nilfisk's 3 year Warranty (conditions apply)
Specifications:- Power Consumption at 415 Volt 7.8 kWatt Current 15.8 Amperes 5 meter cord.
- 1450 RPM long life NA5H pump with 3 ceramic pistons and brass cylinder head.
- 3045PSI 210Bar Cleaning Impact 6.1 kg/Force
- Water Flow 18.5 Lit/min QMAX 17.5 Lit/min QIEC
- Max water inlet temp 40C
- Max Water Temp 90C Max Steam Temp 150C
- 35 litre fuel tank and fuel consumption 4.6 Lit/Hr.
- 20m DN8 HP hose Ergo 2000 gun with Universal Plus 1120 lance and 0500 Tornado Plus nozzle with Neon Green indicator ring
- Dimensions; 119cm Long x 70cm Wide x 99cm High Mass: 165kg
OPERATING INSTRUCTIONS
1. Don't use a surface cleaner above 60 degrees
2. Check the fuel level before use.
3. Check the detergent container is full, and the dial turned off.
4. Pre-select the desired temperature.
5. If the steam is to be used, set the temperature to maximum and back off the steam dial which is found next to the pressure guage two turns anti-clockwise.
6. Then switch on the unit.
IMPORTANT
WHEN HOT WATER / STEAM HAS BEEN USED AND UNIT IS NOT BEING USED FOR AT LEAST 10 MINUTES, TURN THE TEMPERATURE DIALS DOWN AND FLUSH UNIT THROUGH WITH COLD WATER UNTIL THE LANCE IS COLD.
Hot water units should only be used for a maximum of 2 hour at a time before resting for at least one hour, with power and water supplies turned off.
Maximise the FREE FREIGHT offer on this item, on our website, anything purchased along side it, such as in the related items below, will also be shipped free, Australia wide!