Vacuums - Parts & Accessories

Nilfisk and Tellus GA73 and the Nilfisk GS83 and GM83 and the Nilfisk GB733 three phase industrial vacuum cleaner and the Nilfisk GB833 industrial ...

The Nilfisk GM625 Industrial Vacuum Cleaner and the Nilfisk GM626 Industrial Vacuum Cleaner and the Nilfisk GB826 and the oval Nilfisk GB725 3 Ph I...

The Nilfisk GS82 and GM82 Industrial Vacuum Cleaner base dust container with no fittings such as wheels and handles and clips. No longer available,...

The Nilfisk GM625 Industrial Vacuum Cleaner and the Nilfisk GM626 Industrial Vacuum Cleaner and the Nilfisk GB826 and the Nilfisk GB726 3 Ph Indust...

NilfiskCFM127 industrial vacuum cleaner rear pushing handle and the lever, for lifting and lowering the dust container Obsolete and No Longer Avail...

The Nilfisk-ALTO Attix 965-21 SD XC industrial vacuum cleaner and the Nilfisk IVB9 float kit to allow for wet use. This device allows the Nilfisk-A...

NilfiskCFM 175 litre 560mm container diameter ring bracket for ease of emptying by forklift. It's the actual bracket that's suspended from the tine...

This is for the opposite side of the frame as SKU Z8-18505D It's a pivot point for the handle articulation that raises and lowers the dust containe...

NilfiskCFM127 industrial vacuum cleaner handle central body cover for the release latch trigger that connects to the cable. This is Obsolete and No...

Nilfisk-CFM 70mm x 50mm x 50mm Bifurcation Reduction Y Joint This CFM galvanised bifurcation jount is a Y piece of ducting that fits in the 70mm in...

NilfiskCFM 175 litre 560mm container diameter ring for ease of emptying by forklift. It's just the lower part that goes around the container, not t...

Nilfisk and Tellus 32mm original aluminium ball end for repairing rubber industrial vacuum cleaner hoses most usually used on the Tellus and Nilfis...

Nilfisk 38mm industrial vacuum cleaner hose rubber protection rings. They're for protecting hoses from rough surfaces, for example car detailing in...

NilfiskCFM industrial central ducted vacuum system 100mm steel junction fitting. At the moment standard postage within Australia, is capped at a ma...

Nilfisk 38mm chrome steel ball end fitting for repairing or custom making 38mm industrial vacuum cleaner hoses Such as used on the Nilfisk GM80 and...

NilfiskCFM CV10 industrial central ducted vacuum system control box. That's the creamy grey box on the side of the large green square box. As a com...

Nilfisk industrial vacuum cleaner 100mm right angle steel bend for use with very large separators for picking up bulk sand, coal grain etc.This par...

Nilfisk 38mm industrial vacuum cleaner hose steel bayonet kit. Usually fitted on the green conductive rubber hoses that were supplied with the indu...

Nilfisk 50mm ball end for screwing on to the light threaded 50mm internal diameter hose for use with the Nilfisk muff system. It's the one, on the ...

Nilfisk 50mm industrial vacuum cleaner hose rubber protection rings. They're for protecting hoses from rough surfaces, for example in engineering w...

Nilfisk industrial vacuum cleaner hose 50mm chamfered short ball end. Used to repair or make 50mm hoses for the Nilfisk GM82 and the Nilfisk GM625 ...