Skip to content
$30 Maximum postage throughout AUSTRALIA! And FREE postage on orders above $425!
$30 Max postage throughout AUSTRALIA! & FREE postage on orders over $425!

WAP Gerni and ALTO Contractor Master and Standard Petrol Powered Hot Water Pressure Washer NLA

WAP
SKU CONTRACTOR

WAP and GERNI and Nlfisk-ALTO Contractor Master and Standard Heavy-duty Petrol Driven Hot Water High Pressure Washer

Partslist HERE

The Nilfisk-ALTO WAP and Gerni Contractor Master and Contractor Standard offers a wide range of performances with petrol driven engines for fully autonomous use in the construction or industrial segments or by contract cleaners. These units can be open construction, or enclosed silence units.

They giver high efficiency, low cleaning costs and ease of use.

  • EcoPower boiler with > 92% efficiency,
  • Reduced running costs,
  • Slow running direct gear reduction pumps
  • Integrated fuel tank
  • Easy to use control panel,
  • Ergo accessory concept,
  • Honda petrol motors,

OPERATING INSTRUCTIONS

  1. Don't use turbo lance above 80 degrees (Opposite the off position on the main switch).
  1. Don't use a surface cleaner above 60 degrees
  1. Check the fuel level before use.
  1. Check the detergent container is full, and the dial turned off.
  1. Pre-select the desired temperature.
  1. If the steam is to be used, set the temperature to maximum and back off the steam dial which is found next to the pressure guage two turns anti-clockwise.
  1. Then switch on the unit.

IMPORTANT

WHEN HOT WATER / STEAM HAS BEEN USED AND UNIT IS NOT BEING USED FOR AT LEAST 10 MINUTES, TURN THE TEMPERATURE DIALS DOWN AND FLUSH UNIT THROUGH WITH COLD WATER UNTIL THE LANCE IS COLD.

Hot water units should only be used for a maximum of 2 hour at a time before resting for at least one hour, with power and water supplies turned off.

Check the related items below for an alternative machine!